Running fastboot flashing unlock can vary depending on the device you are using. However, generally, the process involves the following steps:
- Firstly, you need to enable developer options on your device. You can do this by going to Settings > About Phone > Build Number and tapping on it multiple times until you see the “Developer Options” enabled message.
- Once you have enabled developer options, you need to enable USB debugging. You can do this by going to Settings > Developer Options > USB Debugging.
- Next, you need to connect your device to your computer using a USB cable.
- Open the command prompt or terminal on your computer and navigate to the folder where the fastboot utility is located.
- Boot your device into fastboot mode by pressing the power button and the volume down button simultaneously.
- Once your device is in fastboot mode, enter the command “fastboot devices” in the command prompt or terminal. This will ensure that your device is connected and recognized by fastboot.
- To unlock the bootloader, enter the command “fastboot flashing unlock” in the command prompt or terminal.
- Your device will display a confirmation message, and you will need to confirm the action by pressing the volume up button.
- Once the bootloader is unlocked, your device will reboot, and you will need to set it up again.
It is important to note that unlocking the bootloader will erase all data on your device, and it may also void your device’s warranty. Therefore, it is important to backup your data before proceeding with this process. Additionally, unlocking the bootloader may also expose your device to security risks, so it is recommended to only do this if you are familiar with the process and understand the risks involved.